Felicity slush fund currently:

£1,409.29

Tuesday, 11 May 2010

Fuel tank

After some thought, I've decided to keep the fuel tank. A new one would be simpler but it is possible to refurbish the tank with kits that completely renew the inner wall after removing any unwanted deposits. It goes against my nature to get a new one, even though the cost is only about £20-30 different from a new tank, I'll refurbish. After all, if I wanted something new I wouldn't be driving a VW!The outside was straight forward. Just need to get that fuel tank kit.

Tuesday, 4 May 2010

Fan shroud

The fan shroud is quite rusty on its inaccessible insides. These wire brushes that fit my drill are whats left of the process so far.

The result is quite good. I'm never really going to be able to reach the inside though. So I thought I'd try a rust bath. One ordinary pallet becomes...
A bath frame?
Seems to be the right size and didn't take to long to make. Perhaps there's a few too many holes at the moment.
Just need to find some plastic sheeting and everything will be ready.

Sunday, 2 May 2010

Oil cooler

Needed to clean up the oil cooler. Wasn't going to be able to reach all the rust of course.It started to look good.

But then disaster as I went through some of the metal.
As you can see the hole is clearly visible. With possibly more holes to be uncovered, I'm not sure its worth the time and effort to repair this. At around £65 these aren't cheap.

Charging the battery

Got the original battery that came with the car. Not sure if it will hold much of a charge anymore.
Only one way to find out.
Got an old charger and hooked it up. Will probably need a new battery but its worth a try.

Kurust

So this is what I'm using on the tinware to stop the spread of rust.

No matter how much you try you can never remove all the rust. Unless that is, you want to start cutting bits out and welding in new bits.
A close-up of the finished surface after kurust.

Saturday, 1 May 2010

Tinware rust removal

Some of the tinware that needs cleaning.
A before shot. I used a drill with a wire brush attachment.

The finished piece. Rust removed.
All the tinware ready for Kurust.
I have decided against any rust removal system because of the time and cleaning process involved. The kurust system just involves painting the kurust on which then make the rust inert. It can then be painted on top of.

Sunday, 18 April 2010

Thermostat holder

One last bit to remove from the engine. The thermostat holder. Only one nut and washer involved and both covered in oil so pretty easy.Just need a clean and paint before refitting.